# How to increase uSD speed

**URL:** <https://genio-community.mediatek.com/t/how-to-increase-usd-speed/1407>\
**Category:** General Discussion\
**Tags:** Genio-510\
**Created:** [November 7, 2025, 10:31am UTC](https://genio-community.mediatek.com/t/how-to-increase-usd-speed/1407 "2025-11-07T10:31:55Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Gian\_Sal](https://avatars.discourse-cdn.com/v4/letter/g/b19c9b/32.png) [@Gian\_Sal](https://genio-community.mediatek.com/u/Gian_Sal)\
**Post date:** [November 7, 2025, 10:31am UTC](https://genio-community.mediatek.com/t/how-to-increase-usd-speed/1407/1 "2025-11-07T10:31:55Z")

</div>

Hi, i’m working on a genio510 and im noticing that running an app from the uSD causes some lags. IS there a way to increase the speed of the Bus ?  
I’ve tested the same app from the nmve and it works fine

thanks

---

<div class="post-metadata">

**Author:** ![ht.lin](https://avatars.discourse-cdn.com/v4/letter/h/67e7ee/32.png) [@ht.lin](https://genio-community.mediatek.com/u/ht.lin)\
**Post date:** [November 28, 2025, 6:21am UTC](https://genio-community.mediatek.com/t/how-to-increase-usd-speed/1407/2 "2025-11-28T06:21:08Z")

</div>

Hi Gian,

You may have a quick check via the command under kernel shell.

#cat /sys/kernel/debug/mmc1/ios

And you should see the following settings if sd-uhs-sdr104 is configured correctly.

If not, please inspect the mmc1(for sd) node settings in both platform and project dts.

clock: 200000000 Hz  
actual clock: 192000038 Hz  
vdd: 19 (3.1 ~ 3.2 V)  
bus mode: 2 (push-pull)  
chip select: 0 (don’t care)  
power mode: 2 (on)  
bus width: 2 (4 bits)  
timing spec: 6 (sd uhs SDR104)  
signal voltage: 1 (1.80 V)  
driver type: 0 (driver type B)
